You have no items to compare.
Genuine ROTAX Parts
Use only Genuine ROTAX Parts, don't compromise the reliability and performance of your ROTAX Aircraft Engine.
Starting at: $1.59
a – For installation of cylinder on the piston 67.5 mm;
b – For installation of cylinder on the piston 72 mm;
c – To hold the fan;
d – For aligning of cylinders at the intake flange;
e – For crankshaft bearing PTO side;
f – For positioning of crankshaft bearing PTO side;
g – For centering of the stator plate;
h – For piston pin 18 mm;
i – For installation of piston pin circlip 18 mm;
j – For the engine;
k – Without ignition and externals
Starting at: $2.13
Starting at: $2.21
C – Loctite 648
E – Loctite Anti-Seize 15378
a – Certified part;
b – 360° anular ring (torus-shaped)
Starting at: $2.83
B – Loctite 243
a – Note Service Instruction SI-912-005 current issue
Starting at: $3.45
L – Klueber Isoflex Topas Nb5051
a - Only for transport
Starting at: $3.45
AR – As required
a – Brush not available as spare part, use brush holder assembly 866891
For Rotax 912iS, 912ULS, 912UL, 618, 503, 447, 377, 277
Previous part number 938-795
Starting at: $5.52
a – For cylinder;
b – For cylinder exhaust flange;
c – For rotary valve shaft;
d – For ball bearing, rotary valve shaft;
e – For oil seal rotary valve shaft (wihout oil pump), intake side;
f – For oil seal rotary valve shaft (with oil pump), intake side;
g – For inner oil seal rotary valve shaft, water pump side;
h – For outer oil seal rotary valve shaft, water pump side;
i – To press in the rotary seal;
j – For rotary valve timing;
k – To pull out the rotary seal - the inner steel bushing of the rotary seal has to be removed before demounting!;
l – For fitting of piston pin circlip;
m – For fitting of piston pin circlip (monohook circlip);
q – To press in the rotary seal 850942 with the insertion jig
Starting at: $7.10
a – For internal hex. screw;
b – To remove the gear cover;
c – To compress the dog gear;
d – For drive gear, I=2,00, I=2,24, I=2,58;
e – For oil seal 850055;
f – For gearbox configuration "B";
g – For oil seal 930715;
h – For oil seal 950085 and 950084;
i – For oil seal 933675;
j – To remove the layshaft gear;
k – To remove the flywheel;
l – For mounting the hardy disk;
m – For gearbox configuration "C";
n – For gearbox configuration "E"
Starting at: $10.54
AR – As required
a – If installed with filter on top;
b – If installed with filter on bottom;
c – not available as a spare part
Starting at: $15.04
a – break away torque 700-900 Nm/516.2 ft.lb - 663.8 ft.lb, b – break away torque 600-800 Nm/442.5 ft.lb - 590 ft.lb