We use cookies to make your experience better. To comply with the new e-Privacy directive, we need to ask for your consent to set the cookies. Learn more.
TANIS 912/914 PREHEATER
$938.85
This preheat system applies heat to strategic locations on the engine including the cylinder heads, crankcase, and oil tank. The kit comes complete with all heating elements, heavy duty wiring harness with 120 volt plug, installation instructions and documentation.
Availability:
In stock
SKU
H9137
This preheat kit contains electrical elements located in each cylinder assembly, one threaded heat element on the engine crankcase (oil pump) and a pad heat element bonded on the oil tank. This multipoint configuration fully preheats the engine and attached accessories. Power is routed to the elements through a dedicated wiring assembly with system power indication and circuit overload protection. System is self-regulating through design. Heated components reach an average state of thermal equilibrium in approximately six hours.
This preheat kit when installed will supply 230 watts with a 2.0 amp draw at 115 volts.
* Required Bonding sealant sold separately, PN: H4302
DRAWING – KIT (System)
2579-115, System Kit Drawing for 4-Cylinder Rotax 912/914 Size: (101.16 KB)
SYSTEM INSTALL INSTRUCTIONS
TNP2579, 4-Cylinder Kit Install Instructions for Rotax 912/914 Engines Size: (953.07 KB)
COMPONENT INSTALL INSTRUCTIONS
TN02788, Bonding of Pad Element Install Instructions (was 186) Size: (121.86 KB)
TN02905, Generic Threaded Element Install Instruction.pdf Size: (1.62 MB)
DRAWING – CABLE KIT/WIRE DIAGRAM
2578, Cable Kit Drawing for Rotax 912/914 Size: (100.41 KB)
| Retail Price | $938.85 |
|---|---|
| Udf EUC | No |
| Udf Special Order | No |